Omnia silicone mold 2.0

Omnia silicone mold 2.0 Silicone mold 2.0 is tailored to fit the Omnia Mini Oven (T19-44). Silicone mold 2.0 is a further development of the original model and has thicker material, is stiffer and ends about 5 mm below the top edge of the aluminum mold. All to better resist if you use a little too high heat. The mold is made of BPA-free silicone, meets FDA standards (US Food and Drug Administration) and LFGB standards (Lebensmittel- und Futtermittelgesetzbush). Before using the silicone mold for the first time, it should be washed in hot water with detergent and dried thoroughly. The inside is lubricated with oil or cooking fat to increase the natural non-stick properties of the silicone mold. The mold should be washed with detergent before each use to enhance the non-stick properties. Wash and dry after use. The silicone mold is placed in the Omnia aluminum mold before pouring in ingredients. Freezer safe and can be used separately in microwave and dishwasher safe. Avoid sharp utensils, scouring pads and the like. Warning: as the silicone mold and Omnia oven get very hot, always use a potholder or equivalent when handling. NOTE! The temperature range is min -30C and max +260C. If the temperature is too high, the silicone mold will be damaged. The mold must not come into contact with an open flame and must not be placed on the stove or under the grill. Follow the Omnia instructions for handling. KA-T19-44E